下面是引用kc715于2005-03-18 13:41发表的 :
连线建立后....

嗯~DNS的设定有没有检查过?

那DNS的设定要去那里检查??
Server本身的nslookup正常ㄚ

连线建立后....

嗯~DNS的设定有没有检查过?

easier way is to use IP in the pop server instead of host name
or
try to add server host name into windows host file - %SystemRoot%\system32\drivers\etc\hosts
look like this:
# email server
xxx.xxx.xxx.xxx     server_name

下面是引用ccxxx于2005-03-23 02:12发表的 :
easier way is to use IP in the pop server instead of host name
or
try to add server host name into windows host file - %SystemRoot%\system32\drivers\etc\hosts
look like this:
# email server
.......

I am always to use IP in the pop server instead of host name .
But the problem is still not fixed.
I think it is server problem not client.

It may caused by ident protocol.
You can change the value in sendmail config file - sendmail.cf

Timeout.ident=1s (even change to 0s)

Remember to recompile the sendmail.cf and restart sendmail daemon.
Hope this can help.